2. Cutting Data with Register Marks
3. Detect register marks.
4. Detecting Register Marks Using Semi-Automatic Detection

1. Detect register marks.

Detecting Register Marks Using Semi-Automatic Detection

If TP1 cannot be placed at the full-automatic register mark detection position or if register marks cannot be detected using full-automatic detection, detect register marks manually.

Detection procedure using front specification

1. Load the sheet, then pull the clamp lever toward you.

• The sheet is held by the pinch rollers.

2. Press to start sheet detection. (Load from rear)

• If [ROLL. SELECT] is set to [ON], select the number of pinch rollers to be used. Setting the Number of Pinch Rollers to Use

• Once the sheet has been detected, the display indicates that the machine is waiting for register mark detection.

• When loading from the front, the positions of TP1 to TP4 will be reversed, as shown in the figure.

3. Use to move the LED pointer close to the center of the register mark detection position, as shown in the following figure.

4. Press the [ENTER/HOLD] key.

• The scale compensation setting screen appears.

5. Use to set the scale correction value.

• Press the [ENTER/HOLD] key to proceed to the next scale compensation setting.

• If [DIST.REVI.] is set to [OFF], the screen for setting scale compensation does not appear.

• If [MARK DETECT] is set to [2ptA], the screen for entering distance B does not appear.

• If [MARK DETECT] is set to [2ptB], the screen for entering distance A does not appear.

• If [MARK DETECT] is set to [1pt], the origin is displayed, and the scale compensation screen does not appear. (Step 7)

6. Press the [ENTER/HOLD] key after setting.

• Register mark detection starts as set using [MARK DETECT].

• [ERROR C36 MARKdetect] appears on the display if no register marks can be detected.
  If this occurs, reload the sheet.

• For more information on the number of register marks detected, refer to Register mark detection points setting [MARK DETECT].

7. Display the origin.

• The available cutting area is displayed following register mark detection, before switching to local mode.

Detection procedure using rear specification

1. Perform steps 1 to 3 of Detection procedure using front specification.

2. Press the [ENTER/HOLD] key.

• Register mark detection starts as set using [MARK DETECT].

• [ERROR C36 MARKdetect] appears on the display if no register marks can be detected.
  If this occurs, reload the sheet.

• For more information on the number of register marks detected, refer to Register mark detection points setting [MARK DETECT].

3. Once the register marks have been detected, set using the scale compensation setting screen.

• The following example shows the procedure for four-point detection.

1. Set using if the detected register mark distances differ from the measured values.

2. Press the [ENTER/HOLD] key to proceed to the next scale compensation setting.

• If [DIST.REVI.] is set to [OFF], the screen for setting scale compensation does not appear.

• If [MARK DETECT] is set to [2ptA], the screen for entering distance B does not appear.

• If [MARK DETECT] is set to [2ptB], the screen for entering distance A does not appear.

• If [MARK DETECT] is set to [1pt], the scale compensation screen does not appear. Proceed to Step 4, and set the origin.

4. Press the [ENTER/HOLD] key after setting.

• Set the origin.

• The available cutting area is displayed before switching to local mode.