1. Helpful Tips

Expanding the Cutting Area [EXPANDS]

The cutting (printing) area can be expanded to reduce non-printing areas. (Expand function)
Expanding the cutting area allows non-printing areas at the front and sides to be reduced by 10 mm.

Figure of expands area
  1. Press the [FUNCTION] key in local mode.
  1. Use updown jog_ to select [SET UP], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select [EXPANDS], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select [ON], then press the [ENTER/HOLD] key.
  1. Press the [END] key several times to exit.
  • Enabling expand mode may result in paper jamming if excessive pressure is applied.
  • If line correction is not performed, the cutting blade may move off the edge of the sheet, causing paper jamming or damaging the cutting blade or machine.
  • Cutting quality will be reduced if the cut part is fed by the pinch rollers.
  • Register marks may not be correctly detected if the pinch rollers move over the register marks during register mark detection.
  • Repeat sheet detection if the expand setting was changed after sheet detection.