Sheet Feed
The sheet can be pulled out in advance before cutting (or printing).
This allows any sheet skew to be checked and prevented.
![](https://d2w577gk9zpoty.cloudfront.net/themes/manual@mimaki/cg-ar-series/operation_manual/en-US/../assets/img/safety-symbols/Important__en-US.png)
- High-speed cutting with a roll sheet still rolled up may result in errors if the sheet drive is unable to keep up.
- The feed function cannot be enabled unless the sheet has been detected.
- Press the [FUNCTION] key in local mode.
- Use
to select [SHEET FEED], then press the [ENTER/HOLD] key.
- Use
to enter the length for pulling out the sheet, then press the [ENTER/HOLD] key.
- Setting: 0.1 m to 51.0 m (in 0.1 m increments)
- The sheet is pulled out by the length corresponding to the entered length plus the feed offset. Feed Settings [FEED OPTION]
![](https://d2w577gk9zpoty.cloudfront.net/themes/manual@mimaki/cg-ar-series/operation_manual/en-US/../assets/img/safety-symbols/Hint.png)
- To stop sheet feed midway, press the [END] key.