1. Feed Settings [FEED OPTION]

PRE FEED Setting

The following automatic sheet feed items can be set to be performed after sheet detection.

Item

Setting

Initial value

Outline

Feed count

(FEED COUNT)

OFF, 1 to 5 (times)

OFF

Sets the number of times the sheet is fed backward and forward. Feeding the sheet increases the cutting (or printing) quality.

  • The feed count should be set to around 3 (times).
  • Adjust the feed count setting to suit the type of sheet used.

Feed length

(FEED LENG)

0.1 to 5.0m

0.3

Sets the length of sheet to be fed.
Feeding the length of sheet to be cut (or printed) beforehand allows the sheet to adjust to the ambient conditions and increases the cutting (or printing) quality.

Waiting time

(TIME WAIT)

0 to 90 seconds

1

Sets the time from feeding the sheet until cutting (or printing) starts.

OVER FEED

ON/OFF

OFF

When cutting (or printing) two or more pages, feeding the second sheet in advance increases the cutting (or printing) efficiency when the waiting time has been set.

  1. Press the [FUNCTION] key in local mode.
  1. Use updown jog_ to select [SET UP], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select [FEED OPTION], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select [PRE FEED], then press the [ENTER/HOLD] key.
  • The feed count setting is displayed.
  1. Use updown jog_ to select the setting, then press the [ENTER/HOLD] key.
  • Setting: OFF, 1 to 5
  1. Repeat Step 5 to set any other items.
  • Set all of the other items using the same procedure as in Step 5.
  1. Press the [ENTER/HOLD] key once all of the items have been set.
  1. Press the [END] key several times to exit.
  • The settings are retained even when the power is turned off.