2. Cutting
3. Installing Tools
4. Using the Cutter
5. Installing the (Supply) Cutter in the Cutter Holder (SPA-0090)
6. Adjusting the Cutting Blade Protrusion Length

1. Installing the (Supply) Cutter in the Cutter Holder (SPA-0090)

Adjusting the Cutting Blade Protrusion Length

1. Turn the adjusting knob to adjust the protrusion of the cutting blade.

• Turn the adjusting knob in the direction indicated by the arrow in the picture to have the blade protrude. (0.5 mm per turn)

2. Check the cutting performance.

• Adjust the pressure so that it leaves slight marks on the base paper. A cutting blade that protrudes too far may damage the machine.
  Setting Tool Conditions
  Test Cutting

• The cutting blade protrusion length can be adjusted while the cutter holder is attached to the tool holder. (0.5 mm per turn of the adjusting knob)