Standards for Register Mark Length and Line Width
recommended register mark size
Available register mark length and line width are as follows. If they are out of the following range, register mark may not be detected or cutting accuracy may be reduced. If the cutting accuracy is reduced, change to recommended register mark size.Register markRegister mark
Register mark size (A) | Register mark length (B) | Register mark line width (C) |
|---|---|---|
200 mm or less | 4 mm or more | 0.5 mm or more |
201 to 500 mm | 8 mm or more | 1.0 to 2.0 mm |
501 to 1000 mm | 15 mm or more | |
1,001 to 2000 mm | 25 mm or more | |
2,001 mm or more | 35 to 40 mm |
- If the "Fill around the register mark" function of the Mimaki cutting software is enabled, the register mark length (B) should be 10 mm or more.
