1. Troubleshooting

If the Shape of a Corner with Miter Specified Differs Between Preview and Output

Depending on conditions such as the shape, corners with a miter specified at the joint may not be output exactly as shown in the preview.

What to do if a miter selection is made_

If this occurs, try the following:

  1. Use frame extraction on the target shape using the following settings:
  • Offset: 0.00
  • Joins: Miter
  • Miter Limit: 4.0
  1. Set the line width and line color for the shape created using frame extraction.
  1. Replace the original shape with the shape created using frame extraction.