- If the cutting position is consistently offset as shown in the figure below, please try adjusting the cut origin position using the offset settings.
Example)
The cutting starts from a position that is shifted 0.5mm to the left and 0.33mm upwards.
![](https://d2w577gk9zpoty.cloudfront.net/archives/046/202309/c401dc66fb08d10316622647a2506551c9ca493974ecf783d6a87d9402f408cb.jpg)
Follow the steps below to adjust the registration mark origin position.
![](https://d2w577gk9zpoty.cloudfront.net/archives/046/202309/0206b14d6573702ab265f9d6b85ce0fab72ebc481597ca0dcf9c6c90f58685c1.png)
(1) On the LOCAL mode screen, press the FUNCTION key or Up/Down key to select [SET UP].
(2) When [MARK DETECT] is displayed, press ENTER.
(3) Press ENTER five times on [MARK DETECT ***]
(4) [offsetA] will be displayed.
A adjusts the feed direction (front and back).
In the example, there is a 0.33mm upward offset. Adjust the value using the up and down key to set it to -0.3mm, then press ENTER.
* If there is a 0.3mm downward offset, set the value to +0.3mm.
* If adjusting in the upward direction, use a positive value; for the downward direction, use a negative value.
(5) [offsetB] will be displayed.
B adjusts the horizontal direction (left and right)
IN the example, there is a 0.5mm leftward offset. To correct this, use the up and down keys to set it to -0.5mm, then press the [ENTER].
* If there is a 0.5mm rightward offset, set it to +0.5mm.
* If adjusting in the rightward direction, use a negative value; for the leftward direction, use a positive value.
(6) Press the [END] key several times to return to the LOCAL screen, and then proceed with cutting as usual.