* The following operating conditions are the results obtained by internal tests.
Note that other problems may be occurred.
* The following operating conditions were tested with SMB connection.
* The software other than listed in the following table does not support macOS 26.

•Yes -> Functions normally.
•Yes* -> Operable, but partially has problems.
•No -> Cannot be used.

Product name	Ver	Operation	Status	Workaround	Plan to support
FineCut/Coat9 for Illustrator	4.1	Yes	It operates normally.	-	Complete
RasterLinkTools for Illustrator	1.22.0	Yes	It operates normally.	-	Complete
When using macOS 26 for RasterLink7 client	4.0.0	Yes	[Hot folder output] It operates normally.Operation is verified under Windows 10, Windows 11	-	Complete
		Yes	[Printer Driver output] Windows 10, Windows 11(21H2): It operates normally. After executing the print, re-authentication of the RIP-PC is required in the printer queue.	-	Complete
		No	[Printer Driver output] Windows 11(22H2 or later): Cannot be used..	-	Not supported
When using macOS 26 for RasterLink6Plus client	2.22	Yes	[Hot folder output] It operates normally.Operation is verified under Windows 10, Windows 11	-	Complete
		Yes	[Printer Driver output] Windows 10, Windows 11(21H2): It operates normally. After executing the print, re-authentication of the RIP-PC is required in the printer queue.	-	Complete
		No	[Printer Driver output] Windows 11(22H2 or later): Cannot be used..	-	Not supported
When using macOS 26 for RasterLinkPro5 client	4.80	Yes	[Hot folder output] It operates normally.Operation is verified under Windows 10, Windows 11	-	Complete
		Yes	[Printer Driver output] Windows 10, Windows 11(21H2): It operates normally. After executing the print, re-authentication of the RIP-PC is required in the printer queue.	-	Complete
		No	[Printer Driver output] Windows 11(22H2 or later): Cannot be used..	-	Not supported
Simple Create	2.0	Yes	It operates normally.	-	Complete

---