Specifications

UJV-160
Head		On-demand Piezo head
Print resolution		600 dpi, 1200 dpi
Ink	Type	LH-100 UV ink (C/M/Y/K/W/CL)
		LF-140 UV ink (C/M/Y/K/Lc/Lm/W)
		LF-200 UV ink (C/M/Y/K/W)
	Capacity	1,200 ml (600 ml × 2 cartridge)/color
Maximum print width		Roll: 1,610 mm (63.3 "), Rigid: 1,600 mm (63.0 ")
Media	Width	1,620 mm (63.7")
	Thickness	Max. 10 mm (0.39")
	Weight	Roll: less than 25 kg (55 lbs.)
		Rigid: less than 12 kg (26.4 lbs.)
	Roll diameter	Inside: 2 inch, 3 inch / Outside: Less than φ180 mm (7.1")
Media cutting		Manual cutting
UV device		Equipped with UV Light Emitting Diodes
Media heater		Pre / print heater
Media take-up device		Roll take-up device (Standard), inside / outside selectable
Interface		USB 2.0
Applicable standard		VCCI class A, UL60950-1, FCCI class A, CE marking (EMC directive, low voltage directive), CB report, RoHS
Power specifications		AC 100 V – 120 V, 200 – 240 V ± 10 %, 50 – 60 Hz ± 1 Hz, less than 1.68 KVA
Operational environments	Temperature	15°C – 30°C
	Humidity	35 – 65 % Rh (No condensation)
Dimensions (W x D x H)	Main unit	3,300mm x780mm x 1,290mm (129.9" x 19.8" x 50.7")
	Main unit + media stand	3,300mm x 4,300mm x 1,290mm (129.9" x 169.3" x 50.7") (Main unit and table with support wire)
Weight	Main unit	260 kg (573 lbs.)
	Media table	50 kg (110 lbs) x 2 units

*Inks would not be cured when printing speed is faster than that of draft mode.

• Some of the samples in this website are artificial renderings.
• Specifications, design and dimensions stated in this website may be subject to change without notice(for technical improvements, etc).
• The corporate names and merchandise names written on this website are the trademark or registered trademark of the respective corporations.
• Inkjet printers print using extremely fine dots, so colors may very slightly vary after replacement of the printing heads. Also note that if using multiple printer units, colors could vary slightly from one unit to other unit due to slight individual differences.

---

---

Precautions for UV printing

Inks and substrates:

• Please note that properties and adhesion, weather resistance etc. of ink and substrates can vary. Therefore please test materials before printing.
• Some substrates require primer before printing. Please test materials beforehand or ask your sales representative.

Safety notice:
You are dealing with UV light sources that may harm your health. Please follow below guidelines strictly:

• Do not look directly into the UV light source nor place your hand, or expose your skin directly to the UV light source.
• Depending upon print mode, there might occur some VOC emittance from printed parts not yet cured and hardened.
• In addition, please read the instructions and guidelines of the manual carefully and follow those.

---